window frame, and Door frames coincide

Posted by Wangkiky Wangkiky over 6 months ago

vertical line is not done, will cause the door does not take on the situation, so the door to Founder, can not warp deformation, the door has just plugged into the window frame, and Door frames coincide. If the door and the box gap is large, mainly because the installation is not allowed to repair the door or the door frame is not perpendicular to the ground, the door can be unloaded to re-plan; such as the door frame is not vertical, should be in the frame plate gasket straight. 3, three door frame chimp tight door frame, fan tongue and groove tight fitting, with rubber cementation and glue wedge to tighten; door frame and the wall should be filled between full. 4, four to see the door set without hollow drums hit the door and window cover side panel, if issued empty drums, it shows that the bottom of the baseboard without mats and other grass-roots sheet, this door is not strong, do. The door sets should be perpendicular to the floor, no bending phenomenon, the door line and the wall surface close. 5, five to see hinge door open door hinge to install a solid, wooden door switch smooth; lock open, lock to be smooth, locked in the door and the door on the two parts to match. Lock is not appropriate, will cause the door switch is not comfortable. In addition, the direction of opening the door to meet the requirements. Part 5: installation and maintenance of finished products to protect [url=http://pvcboardmanufacturer.com/pvc-solutions/58.html]printed pvc ceiling board[/url] [url=http://abcdeckco.com/diydeck/smooth-composite-decking-bar-.html]smooth composite decking bar[/url] [url=http://compositedeck.ml/composite-deck/2876-horizontal-composite-slat-fence-cost.html]horizontal composite slat fence cost[/url]