Connect with
KP Alumni now!

recent registrants


Forums - Reunions - Venues - Gas furnace ignition

Gas furnace ignition

Posted by Wangkiky Wangkiky over 6 months ago

Furnace slag fill is an important preparatory work before opening, to fill foundation in building houses like slag, if the foundation did not play well after the housing will tilt, if no slag fill is likely to cause a partial phenomenon appeared in furnace. Fill hanging ash slag should be large, some factory more attention to this aspect, will be screened to remove fine slag slag and slag slag in small particles should be filled, only to Yu 25 mm clinker in the furnace, but mostly to the size of mixed slag fill in the furnace,[url=http://customvacuumfurnace.com/furnace-sales/China-famous-Brand-Roots-vacuum-pump-with-top-quality.html]China famous Brand Roots vacuum pump with top quality[/url] and the slag accounted for most of the slag should not fill in the furnace. [url=http://buyvacuumfurnace.com/vacuum/1386.html]1700C Vacuum Dental Sintering Crucible Furnace for Laboratory Furnace[/url] To fill in the clinker there for the following requirements: one is the low water requirements (filling in between the skirt and the base of the furnace slag can be high moisture slag slag is two), low carbon content (e.g. less than 20%), if the carbon content is too high, when after the ignition, this part will continue to affect the combustion grate. The ventilation gap between the grate should be cleaned before the slag filling, and the slag should not be filled to the ventilation gap when the slag is filled. Slag fill to the grate (CAP) on the slag deposition is 200 mm, is conducive to the formation of Steamed Buns and ventilation, but some units fill slag for the opposite, 1# grate is slag is basin shaped and low in the middle, edge high, and this may be related to the structure of the ash system (ash faster this case is often used in the form of slag fill edge).[url=http://customvacuumfurnace.com/furnace-manufacturers/2293.html]Factory Cheapest Furnace For Sintering[/url]