Stainless steel high pressure elbow

Posted by Wangkiky Wangkiky over 6 months ago

IF induction heating elbow is an advanced bend method. However, if the elbow process is not appropriate, there may be loose metal pipe damage phenomenon. This damage is manifested as a fine grain boundary crack, the mechanical properties of the pipe and the service life have some adverse effects.[url=http://sheetstainlesssteel.com/stainless-steel/5710.html]Angle Steel 100x100 Steel Galvanized Angle Iron Price[/url] IF corner of the heating range is narrow, uneven temperature inside and outside the wall, pipe in the process of being quenched by the sudden heat, which is inherent weaknesses. Hot simmer big bend is the more original production methods, is in the pipe after the sand, and then the tube heated to simmer system big bend method.[url=http://stainlesssteelcoilprice.com/stainless-steel/3988.html]316 Нержавеющая сталь[/url] The method is more flexible, but the efficiency is not high, energy waste is large, high cost. So far the carbon steel simmer has been less use of this method, but in some non-ferrous metal pipe and plastic pipe in the simmer bend has obvious advantages. The process of the main processes are: sand, heating, bending, sand.[url=http://steelsheetprices.com/steel-sheet/7813.html]stainless steel rod 4mm[/url] After the steel pipe cutting down through the pipe pushing machine in the steel pipe to be bent part of the induction coil, with mechanical arm to catch the head, in the induction loop into the IF current heating pipe, when the steel pipe temperature to plastic state, In the back of the steel pipe with mechanical thrust to promote the bending, bending out of the steel part of the rapid cooling with the coolant, so while heating, while advancing, bending side, while cooling, the bend will bend out.[url=https://www.stainlesssteelgrade.com/bobina-de-acero/3020.html]2205 doble tubo super duplex de acero inoxidable[/url]